LED Cube/Using the Cube: Unterschied zwischen den Versionen

Aus Wiki CCC Göttingen
Wechseln zu: Navigation, Suche
(LED Cube Operation)
Zeile 7: Zeile 7:
 
* '''Bootloader Mode''': In the bootloader mode, the LED Cube will enumerate at the USB Host it is connected to. You are then able to transfer a new application to the LED Cube.
 
* '''Bootloader Mode''': In the bootloader mode, the LED Cube will enumerate at the USB Host it is connected to. You are then able to transfer a new application to the LED Cube.
 
* '''Application Mode''': In this case, the application that has been loaded last time when the LED Cube was in the bootloader mode will start.
 
* '''Application Mode''': In this case, the application that has been loaded last time when the LED Cube was in the bootloader mode will start.
 +
 +
The mode the LED cube will start in is set by the bootloader jumper. When it is on the left side, the LED Cube will be in the bootloader mode after startup.
 
<gallery perrow=2 widths=300 heights=200>
 
<gallery perrow=2 widths=300 heights=200>
 
File:Lcpcb-10-02.jpg|the bootloader jumper in bootloader mode
 
File:Lcpcb-10-02.jpg|the bootloader jumper in bootloader mode
 
</gallery>
 
</gallery>
 +
 +
If, on the other hand, it is on the right two pins or completely removed, The LED Cube will enter the application mode.

Version vom 5. Mai 2012, 22:05 Uhr

LED Cube Series

Lc-front.jpg

Chapter 1: Build

Section 0: Preparation and Requirements

Section 1: PCB Soldering Manual

Section 2: Cube Soldering Manual

Section 3: Assembly and Testing

Chapter 2: Play

Using the Cube

Creating an Animation

Chapter 3: Learn

Understanding the Electronics

Custom Programs

Now we will learn to use the cube. But, first of all some theory.

LED Cube Operation

When powering up the LED Cube, it can be in one of two modi:

  • Bootloader Mode: In the bootloader mode, the LED Cube will enumerate at the USB Host it is connected to. You are then able to transfer a new application to the LED Cube.
  • Application Mode: In this case, the application that has been loaded last time when the LED Cube was in the bootloader mode will start.

The mode the LED cube will start in is set by the bootloader jumper. When it is on the left side, the LED Cube will be in the bootloader mode after startup.

If, on the other hand, it is on the right two pins or completely removed, The LED Cube will enter the application mode.